Avenview KVM-C5 Series Uživatelský manuál stáhnout pdf (Strana 9)

www.avenview.com

d. Connect Cable: Plug two ends of Cat 5 / 5e / 6 cable to Transmitter and Receiver’s RJ45

“SYSTEM LINK” ports. Now the LEDs above RJ45 should turn on to indicate the activation of

Video Signal and correct connection of the cable.

Connection Diagram of VTS-C5 Series Extender

e. Function Test: Power on your PC and Touch Screen or VGA Data Device. Test the function of

Touch Screen. During the operation, the STATUS LED will blink on Blue and Red to indicate

the Tx/Rx communication.

f. Manual VGA Adjustment: The video quality can be manually adjusted by the Control of

GAIN and FOCUS at the back of the Receiver unit.

General Troubleshooting

Problem

Possible Solution

Screen Defects Appear

 Check that VGA resolution and frequency is not over the

limit of monitor display.

 Check your current resolution, refresh rate and color depth

settings in the Settings and Monitor tabs in your Display

Properties dialog.

Off-Center Screen Image, Odd

Colors or No Picture

 Try adjusting the brightness, sharpness, contrast, and color

balance controls of your monitor.

 Try adjusting the centering and positioning controls of your

monitor to position the picture on the screen.

No Image

 Ensure that the monitor cable is securely fastened to the

VGA and Monitor port.

1 2 3 4 5 6 7 8 9 10 11 12

Žádné komentáře

Avenview KVM-C5 Series Uživatelský manuál Strana 9